By -



Who and what is Tinius Olsen ? Click here and discover Tinius Olsen Testing Machine Company

 

Comments

Post a Comment

Popular posts from this blog

Testing Wet Tensile Strength of Absorbent Paper

By -
Image
On the way of innovation, Tinius Olsen now uses its Tensile Testing Machine to put up a test to measure the wet tensile strength and performance of tissue and absorbent paper. Wet tensile strength is the maximum force supported by the unit width of a wet test piece of tissue/absorbent paper until the onset of rupture using a tensile test. EN 12625 defines th e preparation of the test specimen in terms of the edge quality and dimensional tolerances . The test specimen is placed into a Tinius Olsen tensile testing machine upper clamp so that a loop is produced around what is called the “Finch” soaking device bar; the soaking vessel containing water is raised allowing soaking for 15 seconds, the tensile force is then applied & once the specimen ruptures, the soaking vessel is removed. Results are automatically reported through Horizon test software in terms of Mean wet tensile strength (N/m) & Relative wet tensile strength (%) which qualifies the strength &...
Read more

Grip Jaw Face Solution for Tensile Specimens Cut from Pipe

By -
Image
When conducting tensile tests on sections cut from pipes, be it plastic gas or water pipes or steel pipes, the resulting test specimen dumbbell or “coupon” shape (dimensions of which are defined by the relevant test standard be it ISO, ATSM, GB, GOST etc) exhibits the curve of the pipe, this means it cannot generally be held for the duration of the tensile test using flat parallel grip faces as the curvature of the specimen prevents a good amount of contact between the specimen and the grip faces. The solution is a grip face which mirrors the profile of the curve in the pipe (dumbbell or coupon specimen) a V on one side and radius on the other;   At Tinius Olsen we are able to precisely manufacture and supply such faces to mirror the radius of any curved specimen and implement in our tensile wedge action grips. The faces typically have a 2 mm pitch serration and hardened to 60RC in support of good specimen gripping. The faces are interchangeable for diff...
Read more

S274 - Mesh Weld Shear Test

By -
Image
This attachment is used to test the strength of the welds that hold mesh together. The mesh is often used as a reinforcement for concrete structures. as this is a structural component it is essential to test the consistency of the weld in any given section. A joint is cut from the mesh and placed in this attachment. A grip, the HW 14 is then placed on the end of the rod. a force of up to 50 kN is then applied and the shear strength of the weld measured. There is some adjustment in the design with a sliding plate that allows for different gauges of wire. The applicable standards are: BS4483, ASTM A185, ASTM A497 and ASTM A974. The testing application note for this grip is available from the resource area of our School of testing microsite or by clicking here .
Read more